二手 DELATECH 859 #150921 待售

CDO system Thermal reaction section: 800°C Resistive heating element and cylindrical liner Recirculating water scrubbing section Spray chamber in primary cooling / Scrubbing for liquid Scrubbing of soluble gases and particulate Counter-current packed bed liquid scrubber Liquid scrubbing and fine particulate removal Exhaust port inlets: Up to (4) 1 ½" Process inlet: 100 SLM Per inlet Conductivity liquid level sensor with purge Magnehelic: 0.5" to 5" Temperature controller Exhaust moisture suppression system Ground fault circuit interrupt Water saving recirculation system Sump pump to drain Ports: Single port: KF-50 2" Two port: KF-40 1.5" Four port: KF-40 1.5" CDI Exhaust: Halar coated stainless, 4": 315 L Or PVDF Connection: ISO (100mm) Required draw/Flow: 4.5" to .5" WC, 20 CFM maximum Cabinet exhaust: Metal duct, 6" Connection: 85 CFM Minimum System status output: Connector 3-Pin mic jack Dry contact pins: 1 (NC), 2(NC), 3 (COM) Maximum amps: 2A at 24 VAC Tool interlock: (4) Connectors 2-Pin mic jack (4) Dry contact pins: 1 (NC), 2(COM) Maximum amps: 2A at 24 VAC Remote indication: 37-Pin amphenol connector, 100" Nitrogen: Pressure: 85 ± 15 psi 3/8" Regulated / constant stainless compression filtered to 5µ Required draw/Flow: 200 SLM system flow requirement Clean Dry Air (CDA): Pressure: 90 ± 10 psi 1/2" Stainless compression constant, regulated Required draw/Flow: 300 SLM System flow requirement Relative humidity: ≤ 10% Water fresh < 100 mg/liter of hardness: Pressure: 60 ± 15 psi 1/2" FNPT Constant, regulated filtered to 100µ Required draw/Flow: 0.75 GPM Cooling water return: FNPT, 1" Required draw/Flow Cooling water supply: Pressure: 40 ± 20 psi FNPT, 1" Required draw/Flow: 10 GPM at 50°F ± 10°F IW Drain: Pressure: Sump pumped FNPT, 1/2" Required draw/Flow: TE-5 20 GPM, TE-7 GPM Drain / Drip tray: Pressure: gravity Connection: 1" FNPT Thermal properties with recirculation / Sump pump: Media: Cabinet exhaust BTUs/Hour: 771 Calculated using: 85 cfm Media: City water BTUs/Hour: 3375 Calculated using: 0.75 gpm Media: CDO Exhaust BTUs/Hour: 102 Calculated using: 20 cfm Media: Electrical drawer BTUs/Hour: 335 Calculated using: 35 cfm Temperature: 25°C ± 5°C Humidity: < 70% Power supply: 208/220VAC, 110VAC, Single phase, 50/60Hz, 40A, 4-wire.