二手 SEICA Pilot LX #9200893 待售

Flying probe tester Access above UUT: (4) Independent topside flying probes with active test heads (2) CCD Cameras Camera 1: Optical alignment and vision tests Camera 2: Debug and real-time probe viewing Access below UUT: (8) Fixed bottom side analog In-circuit channels Expandable with 1024 analog / 512 programmable hybrid channels (64) Bottom side fixed open fix probes System capabilities: Open expandable architecture (IEEE-488, VXI, Boundary Scan) Linear guides with roller-bearing technology Brushless motors with integrated encoders for X and Y movements Stepper motors with encoders for Z-movements Positioning resolution: 2.5 μm (0.1 mils) X-Axis, 2.5 μm (0.1 mils) Y-Axis Positioning repeatability: ± 3 μm (0.12 mils) Test speed: 12-20 test /s Test area & UUT Characteristics: Test area: 610 mm x 610 mm Maximum testable board size: 610 mm x 1016 mm Minimum board width: 34 mm Maximum PCB thickness: 5 mm Edge clearance: 3 mm Maximum component height (top): 45 mm (1.77") Including PCB thickness Maximum component height (bottom): 100 mm (3.9"), 200 mm (7.8") with lowered plate Minimum pad size: 75 μm (2.96 mils) Minimum pad pitch (distance between two test points, center-to-center): 200 μm (7.88 mils) Board alignment: Automatic optical alignment Board loading: Manual Automatic with SMEMA interface: Conveyor direction: L to R, R to L, Programmable Rail length (X): 1680 mm Maximum opening between rails: 610 mm Minimum opening between rails: 34 mm Load / Unload cycle time: 4s to 6s Conveyor speed: 5 to 30 m / min (33 ft / min) Air supply: Compressed air supply: Typical 6 atm (88.2 PSI) Air flow: 1 N/L Minimum (6 L/min) Air compressor capacity: 10 L/m Minimum PC: Intel pentium IV PC Operating system: Windows 2000 / XP Networking card Power supply and consumption: 110 V -10% to +15%, 2500 W / 230 V -10% to +15%, 2500 W 2003 vintage.